How to Install Own Network Cables

Wired connection of your home to the network is the only way to get the most productive system, including a system with a large number of network clients.

Installing cables is certainly a problem, and sometimes it can be so for a rather unusual reason. The actual physical work of laying cables from one place to another is the most difficult part of connecting a home to the network.

If you are not confident in your abilities, it is better to contact a specialist who provides Network Cable Installation in London service.

What you need

First of all, you need to figure out the places where you need the Network Cabling London. The network cable has two ends. As a rule, they are both the same. But we will call them A and B for greater understanding.

A is where the cable starts and B is where it ends. In particular, end A is connected to a switch, and end B is connected to a wired device.

Finding out locations

You only need two cables to have a wire-feedback mesh system in many homes.

In this case, you are laying a cable from the router to the place where you need to place the satellite device, which should be at the other end of the house, or at least in the middle of it.

Alternatively, you can route the cable from the modem to where you need to place the router. It’s all about placing the equipment correctly to ensure the best coverage.

On the other hand, if you want to do your best and connect the whole house, you will need a place where the ends of all the cables converge.

Which network cable to take

If you need to lay the cable only in an open space, you can use a ready-made long cable. But, most likely, you will have to install cables behind the wall, outside, under the floor, etc.

In fact, it’s not as difficult as it may seem at first glance.

Photo by Gavin Allanwood on Unsplash